This is a 100% Original and Authentic Dremel Product. We do not sell imitation copy..
Quality cutters for detail engraving, carving and routing in wood, fiberglass, plastic and soft metals.
Ideal engraving, carving and routing
Use on wood, fiberglass, ceramics, plastic, jewelry and soft metals
Recommended for detail work
Secure objects to a stable surface while working.
For best results, insert the accessory bit all the way into the tool and then back it out slightly before tightening down. This provides plenty of shank for the collet or chuck to hold onto the bit.
Use the sides of the cutter (rather than the tip) for effective cutting. The tip cuts poorly and can break under pressure.
Use higher speeds for hard woods, slower speeds for metals and very slow speeds for plastics (to avoid melting at the point of contact).
If chattering occurs, increase speed.
Model : 106
Bit Diameter : 1/16" (1.6mm)
Description : Engraving Cutter
Shank Diameter : 3/32" (2.4mm)
For more information Kindly contact
Tel : 013-9341595 @ 012-6207883 @ 03-92055282 (During office hours)
EH Global @ Touch D.I.Y
Block 10-8-8, Queen's Avenue, Jalan Bayam,
Off Jalan Peel, Cheras 55100 Kuala Lumpur,
Monday - Friday 9am-6.30pm
We accept Credit Card, Cash or Bank Transfer.
Other Terms & Conditions:
1 year warranty on manufactured defect