1KW Panasonic A5 series servo, middle inertia(MDME102GCG+MDDHT3530E)
With our 15 years experience in this field, we can offer you professional advice and technical support.
We mainly supply servo motors to our CNC control system customers, in CNC cutting machne field, mostly used servos are Mitusubishi E series, J2S series, Panasonic A4,A5 series.
Usually on X axis, in US called Y axis, ( transverse direction), it is a 400W servos.
On longitude, if the load below 1500kg, dual drive, 750W servo is enough.
Over this load, 1kw servo is a must.
We can supply it with planetary gearbox.
1KW Panasonic A5 servo motor and drive, middle inertia.
Or position mode and Analog mode both.
We may supply it according to your CNC system type, and support you to wire it up.
Serious Buyer only
Call after 12pm, busy morning
more other model
worm Gear motor
Other Terms & Conditions: