Assalam and good day to all rc pilot..
A famous well known flight controller for all types of quadcopter DIY design..For sale
Configuration Procedures as below..
ESCs all need to be Connected all to CC3D
GCS (Ground Control Station) install from cc3d official web.
Use the simple Setup Wizard to configure CC3D
Please note that you need a Mini USB Cable to connect CC3D and your PC
The setup is pretty easy and straight forward using the Wizard
Connect cables between CC3D and Receiver
The cables might be different depends on batch but you can first try to connect the cable to the
1 x OpenPilot CC3D Flight Controller (Bent Pin With Case)
1 x Set Cable
JIKA BERMINAT, BOLEH WASSAP SAYA,
KHAIRUL RC DI TALIAN 0136807110 ATAU COD DI
Thank you Mudah...