Made in USA.
Content: 1 piece
Remark: Yellow - Fine
Green - Coarse
These burrs rip through wood faster & cleaner than any similar! Perfect for all shaping uses; in forward or reverse rotation. Unlike other burrs that use a random grit pattern, the carbide barbs are sharper, have lower tooth angle & are structurally aligned in a precise pattern. The razor sharp carbide teeth are arranged into a unique open pattern to resist loading while providing rapid stock removal and a smooth finish. The result is faster cutting, plus amazing resistance to loading.
The manufacturers say: "Structured carbide toothed carving burrs utilising a staggered tooth design that cuts quickly and efficiently, leaving a clean chip-free surface that only an abrasive burr can provide."
On picking them up, the range look high quality, and seem to be well-built. The teeth are very sharp and are randomly placed. They are also of a very uniform tooth length. It is nice to see the easy colour coding of the pieces. We have not worn out the colour on a bit yet, but even if it does in the years to come, one can still see the neat and highly visible tooth forms to identify the grade of finish possible from it.
All the solid bits used ran true and did not distort under load or pressure. We only had a small selection of what is available so one can pick and mix from a wide range to suit your needs. There is an incredible degree of control with these blades, and they tend not to run or pull away from you in the way that some others do.
Not for use on METAL or CERAMICS.
Safety: Always use approved eye protection and safety devices!
Sizes: Coated diameters are nominal and may vary in size by .150"
Recommended Operating Speed: 4,000 to 24,000 RPM'S
For more information Kindly contact:
Tel : 013-9341595 @ 012-6207883 @ 03-92055282
(During office hours)
EH Global @ Touch D.I.Y
Block 10-8-8, Queen's Avenue, Jalan Bayam,
Off Jalan Peel, Cheras 55100 Kuala Lumpur,
Monday - Friday 9am-6.30pm
We accept Credit Card, Cash or Bank Transfer.